Browsing eNauka
Browsing by Author Kakaš, Damir
Showing results 1 to 10 of 10
| Issue Date | Title | Author(s) | Type | Мp-cat. |
|---|---|---|---|---|
| 2012 | A correlation to describe interfacial heat transfer coefficient during solidification of Al–Si alloy casting | Kovačević, Lazar   ; Terek, Pal ; Kakaš, Damir; Miletić, Aleksandar | Article | 21aM21a |
| 2014 | Determination of AFM surface roughness parameters and topography of contemporary dental nanocomposites after artificial saliva storage | Blažić, Larisa ; Lainović, Tijana ; Vilotić, Marko ; Kukuruzović, Dragan ; Kakaš, Damir | Conference Paper | Mp. category will be shown later |
| 2013 | Determination of surface roughness and topography of dental resin-based nanocomposites using AFM analysis | Lainović, Tijana ; Vilotić, Marko ; Blažić, Larisa ; Kakaš, Damir; Marković, Dubravka ; Ivanišević, Aljoša | Article | 23M23 |
| 2013 | Effect of diamond paste finishing on AFM surface texture parameters of dental nanofilled and nanohybrid composites polished by two different procedures | Lainović, Tijana ; Blažić, Larisa ; Vilotić, Marko ; Kakaš, Damir | Article | Mp. category will be shown later |
| 2015 | Improvement of Ejection Test Used for Evaluation of Soldering Tendency Between Casting and Die Materials | Terek, Pal ; Kovačević, Lazar ; Miletić, Aleksandar ; Kukuruzović, Dragan ; Škorić, Branko ; Kakaš, Damir | Conference Paper | Mp. category will be shown later |
| 2011 | Influence of substrate roughness on adhesion strength of hard TiN films | Kakaš, Damir; Škorić, Branko ; Miletić, Aleksandar ; Terek, Pal ; Kovačević, Lazar ; Vilotić, Marko | Conference Paper | Mp. category will be shown later |
| 2010 | Karakterizacija površina mikro i nano prevlaka : monografija | Škorić, Branko; Kakaš, Damir | Monograph | Mp. category will be shown later |
| 2014 | TEM study of low carbon steel subjected to severe plastic deformation by multistage compression | Vilotić, Marko ; Šiđanin, Leposava ; Dženg, J.; Aleksandrov, S.; Kakaš, Damir | Conference Paper | Mp. category will be shown later |
| 2013 | The comparison of AFM surface texture parameters of dental nanohybrid composite polished by two different procedures | Lainović, Tijana ; Blažić, Larisa ; Vilotić, Marko ; Kukuruzović, Dragan ; Kakaš, Damir | Conference Paper | Mp. category will be shown later |
| 2012 | The effects of cutting parameters and tool wear on the roughness of machined surface | Kukuruzović, Dragan ; Blagojević, Danijel; Kakaš, Damir; Škorić, Branko ; Kovačević, Lazar ; Terek, Pal ; Miletić, Aleksandar ; Vilotić, Marko | Conference Paper | Mp. category will be shown later |