Researchers
Babić, Miroslav
Rezultati 61-80 od 114
| Godina | Naslov | Autor(i) | Tip rezultata | Mp-kat. |
|---|---|---|---|---|
| 2012 | Baza podataka triboloških istraživanja | Erić, Milan | Tehničko rešenje | Mp kategorija će biti prikazana naknadno. |
| 2012 | Tribological Potential of Hybrid Composites Based on Zinc and Aluminium Alloys Reinforced with SiC and Graphite Particles | Mitrović, Slobodan | Article | Mp. category will be shown later |
| 2012 | WEAR AND FRICTION PROPERTIES OF SHOT PEENED SURFACES OF 36CRNIMO4 AND 36NICRMO16 ALLOYED STEELS UNDER DRY AND LUBRICATED CONTACT CONDITIONS | Mitrović, Slobodan | Conference Paper | Mp. category will be shown later |
| 2012 | Studies on Micro and Nanotribological Behaviour of Ti alloys and polymer | Babić, Miroslav | Conference Paper | Mp. category will be shown later |
| 2012 | VARIABLE DRAWBEAD HEIGHT AND VARIABLE CONTACT PRESSURE AS TRIBOLOGICAL INFLUENCES IN SHEET METAL STRIPE SLIDING TEST | Aleksandrović, Srbislav | Article | 23M23 |
| 2012 | Wear Behaviour of Hard Cr Coatings for Cold Forming Tools Under Dry Sliding Conditions | Mitrović, Slobodan | Article | Mp. category will be shown later |
| 2011 | Tribological Potencial of Hybrid Composites Based on Zinc ond Aluminium Alloys Reinforced with SiC and Graphite Particles | Mitrović, Slobodan | Conference Paper | Mp. category will be shown later |
| 2011 | Tribology in Biomaterials Design and Selection | Živić, Fatima | Conference Paper | Mp. category will be shown later |
| 2011 | Tehnološki postupak dobijanja dvojnog hibridnog kompozita sa osnovom od A356 legure aluminijuma uz dodatak 10 mas. % čestica SiC i 1 mas. % čestica grafita | Bobić, Ilija | Technical reports | Mp. category will be shown later |
| 2011 | Influence of sliding speed and surface roughness on the friction coefficient and wear TiN coatings deposited at low temperature![]() | Kakaš, Damir | Konferencijski rad | Mp kategorija će biti prikazana naknadno. |
| 2011 | Continuous control as alternative route for wear monitoring by measuring penetration depth during linear reciprocating sliding of Ti6Al4V alloy | Živić, Fatima | Article | 21aM21a |
| 2011 | Microindentation of Polymethyl Methacrylate (PmMa) Based Bone Cement | Babić, Miroslav | Konferencijski rad | Mp kategorija će biti prikazana naknadno. |
| 2011 | Application of Contemporary Information Technologies in Nanotribometry![]() | Erić, Milan | Article | Mp. category will be shown later |
| 2011 | Corrosion Behaviour of the As-Cast and Heat-Treated Za27 Alloy | Bobić, Biljana | Conference Paper | Mp. category will be shown later |
| 2011 | Corrosion behaviour of the as-cast and heat-treated ZA27 alloy | Bobić, Biljana | Article | Mp. category will be shown later |
| 2011 | Tribological Properties of Shot Peened Surfaces of 36NiCrMo16 Alloyed Steels in Dry Sliding Condition | Babić, Miroslav | Conference Paper | Mp. category will be shown later |
| 2011 | Wear Behaviour of Cr Hard Coatings for Cold Forming Tools Under Dry Sliding Conditions | Mitrović, Slobodan | Konferencijski rad | Mp kategorija će biti prikazana naknadno. |
| 2011 | A failure analysis of a massive excavator reduction gear in surface mining using vibration-based condition monitoring![]() | Todorovic, Petar | Naučni članak | 23M23 - Međunarodni časopis kategorije M23 |
| 2011 | The effect of shot peening on tribological behavior of alloyed steels | Babić, Miroslav | Conference Paper | Mp. category will be shown later |
| 2011 | VARIABLE TRIBOLOGICAL CONDITIONS ON THE FLANGE AND NONMONOTONOUS FORMING IN DEEP DRAWING OF COATED SHEETS | Aleksandrović, Srbislav | Article | 23M23 |
