Researchers
Babić, Miroslav
Results 61-80 of 114
| Issue Date | Title | Author(s) | Type | Мp-cat. |
|---|---|---|---|---|
| 2012 | Effect of vacuum-treatment on deformation properties of PMMA bone cement | Živić, Fatima | Article | 21aM21a |
| 2012 | WEAR AND FRICTION PROPERTIES OF SHOT PEENED SURFACES OF 36CRNIMO4 AND 36NICRMO16 ALLOYED STEELS UNDER DRY AND LUBRICATED CONTACT CONDITIONS | Mitrović, Slobodan | Conference Paper | Mp. category will be shown later |
| 2012 | Studies on Micro and Nanotribological Behaviour of Ti alloys and polymer | Babić, Miroslav | Conference Paper | Mp. category will be shown later |
| 2012 | Tribological Potential of Hybrid Composites Based on Zinc and Aluminium Alloys Reinforced with SiC and Graphite Particles | Mitrović, Slobodan | Article | Mp. category will be shown later |
| 2012 | VARIABLE DRAWBEAD HEIGHT AND VARIABLE CONTACT PRESSURE AS TRIBOLOGICAL INFLUENCES IN SHEET METAL STRIPE SLIDING TEST | Aleksandrović, Srbislav | Article | 23M23 |
| 2012 | Wear Behaviour of Hard Cr Coatings for Cold Forming Tools Under Dry Sliding Conditions | Mitrović, Slobodan | Article | Mp. category will be shown later |
| 2011 | Tehnološki postupak dobijanja dvojnog hibridnog kompozita sa osnovom od A356 legure aluminijuma uz dodatak 10 mas. % čestica SiC i 1 mas. % čestica grafita | Bobić, Ilija | Technical reports | Mp. category will be shown later |
| 2011 | Tribological Potencial of Hybrid Composites Based on Zinc ond Aluminium Alloys Reinforced with SiC and Graphite Particles | Mitrović, Slobodan | Conference Paper | Mp. category will be shown later |
| 2011 | Tribology in Biomaterials Design and Selection | Živić, Fatima | Conference Paper | Mp. category will be shown later |
| 2011 | Continuous control as alternative route for wear monitoring by measuring penetration depth during linear reciprocating sliding of Ti6Al4V alloy | Živić, Fatima | Article | 21aM21a |
| 2011 | The effect of shot peening on tribological behavior of alloyed steels | Babić, Miroslav | Conference Paper | Mp. category will be shown later |
| 2011 | Kompoziti sa dobrom otpornošću na habanje dobijeni infiltracijom čestica silicijum-karbida (SiC) i čestica grafita u osnovu od aluminijumske legure A356 | Bobić, Biljana | Arch works | Mp. category will be shown later |
| 2011 | VARIABLE TRIBOLOGICAL CONDITIONS ON THE FLANGE AND NONMONOTONOUS FORMING IN DEEP DRAWING OF COATED SHEETS | Aleksandrović, Srbislav | Article | 23M23 |
| 2011 | Wear Behaviour of Cr Hard Coatings for Cold Forming Tools Under Dry Sliding Conditions | Mitrović, Slobodan | Conference Paper | Mp. category will be shown later |
| 2011 | Wear Behaviour of TiN Coatings for Cold Forming Tools under Dry Sliding Conditions | Mitrović, Slobodan | Conference Paper | Mp. category will be shown later |
| 2011 | Influence of sliding speed and surface roughness on the friction coefficient and wear TiN coatings deposited at low temperature![]() | Kakaš, Damir | Conference Paper | Mp. category will be shown later |
| 2011 | Wear Behaviour of Ti6al4v Alloy Against Al2o3 under Linear Reciprocating Sliding | Zivic, F. | Article | 23M23 |
| 2011 | Corrosion Behaviour of the As-Cast and Heat-Treated Za27 Alloy | Bobić, Biljana | Conference Paper | Mp. category will be shown later |
| 2011 | Application of Contemporary Information Technologies in Nanotribometry![]() | Erić, Milan | Article | Mp. category will be shown later |
| 2011 | Influence Of Al2O3 Particle Content On The Sliding Wear Behaviour Of Za-27 Alloy Composite | Mitrović, Slobodan | Conference Paper | Mp. category will be shown later |
