Pretraga
Rezultati
Optimizing cutting parameters in tube turning using Taguchi method [2013]
Radovanović, Miroslav
Cost optimization of abrasive water jet cuttng using GA [2013]
Radovanović, Miroslav
INFLUENCE OF LUBRICANT ON THE COEFFICIENT OF FRICTION CHANGE OF HYBRID AL-SIC-GR COMPOSITES [2013]
Babić, Miroslav; Stojanović, Blaža 
; Mitrović, Slobodan ; Bobić, Ilija ; Miloradović, Nenad ; Pantić, Marko
Metal-metal composites with Zn-Al alloy base and addition of Ti microparticles reinforced with ceramic nanoparticles [2018]
Vencl, Aleksandar ; Šljivić, Veljko; Bobić, Ilija
Effects of different finishing procedure onto nanomechanical and nanotribological characteristics of lithium disilicate glass ceramics.
[2016]
Pantić, Marko M. ; Mitrović, Slobodan R. ; Babić, Miroslav J. ; Jevremović, Danimir P. ; Džunić, Dragan S. ; Kanjevac, Tatjana V. ; Adamović, Dragan D.
WEAR AND FRICTION PROPERTIES OF SHOT PEENED SURFACES OF 36CRNIMO4 AND 36NICRMO16 ALLOYED STEELS UNDER DRY AND LUBRICATED CONTACT CONDITIONS [2013]
Mitrović, Slobodan ; Babić, Miroslav ; Adamović, Dragan ; Živić, Fatima ; Džunić, Dragan ; Pantić, Marko
Investigation on surface roughness of curbon steel machined by abrasive water jet using Taguchi method [2014]
Radovanović, Miroslav
Investigation of surface roughness in abrasive water jet cutting using Shainin method [2015]
Radovanović, Miroslav
Influence of "Valena" metal-plating additive on the friction properties of ball bearings [2014]
Kandeva, Mara; Vencl, Aleksandar ; Assenova, Emilia
Ерозийно износване на никелови покрития с наноразмерни частици от силициев карбид [2013]
Kandeva M.; Karastoяnov D.; Vencl, Aleksandar
Filteri
Po tipu
- 23